Pull Big Pipe

When it comes to handling large diameter pipe, four beams are better than two. This unit has four cleated, non-marking belt assemblies with plenty of contact length for maximum pulling power without distortion.

Cleated Pipe Puller

Designed to accurately pull pipe or tubing from 3 inches (76 mm) to 13.2 inches (335 mm) in diameter, this unit has four belt assemblies (beams) positioned above, below and on either side for maximum support and control. Each of the belt assemblies is powered by its own AC motor and speed reducer. All four are coordinated to run at the same speeds by a single electronic drive. The position of the bottom and front beam assemblies are set manually for precise alignment, while the top and rear assemblies open and close pneumatically to ease set-up.

Check out these exciting features and capabilities:

• V-shaped cleats
• Speed range 1.6 to 32 ft/min (0.5 to 10 m/min)
• Closed-loop control optional
• Beams pivot to accommodate odd shapes at start-up
• Models available for pipe to 36 inches (0.9 m)
• Fully guarded for operator safety